ELECTRICAL PARTS - ENGINE
Showing 1–30 of 91 results
In Stock356 / 912 PULLEY SPACER #539.09.314
Spacers for pulley on 356 ABC (1950-65), and 912 (1965-69).
£2.37 ex. VAT
In StockInner Half Pulley Gold W/Notch #539.09.315
Gold finish inner half pulley with notch for generator on all 356/912.
£12.10 ex. VAT
In StockInner Half Pulley Silver W/Notch #539.09.315A
Silver finish inner half pulley with notch for generator on all 356's and some early 912.
£19.22 ex. VAT
In StockOuter Half Pulley Gold W/O Notch #539.09.316
Gold finish outer half pulley with no notch for generator on all 356/912.
£12.10 ex. VAT
In StockOuter Pulley – Silver #539.09.316A
Silver finish outer half pulley with no notch for generator on all 356's and some early 91
£17.88 ex. VAT
In Stock356 / 912 Generator Pulley Nut #547.09.303
356 (1950-65) and 912 (1965-69).
£26.92 ex. VAT
In Stock356 / 912 FAN HOUSING GASKET #616.106.125.00
The is the fiber gasket between the fan housing and the cover. It fits 356B,C and 912.
£4.25 ex. VAT
In Stock356 / 912 Pulley Woodruff Key #N.012.705.1
Woodruff key for Dynamo pulley on 356 ABC (1950-65), and 912 (1965-69) Genuine Porsche.
£2.90 ex. VAT
In StockPertronix Flame Thrower 40k Volt #40011.40511
Pertronix Flame Thrower 40k Volt Ignition Coil. Recomended to go with Pertronix ignitor. 1
£55.73 ex. VAT
In StockIGNITION WIRE PLUG GROMMET #539.09.201
Spark plug connector boot for all 356 (1950-65), 911 (1965-89), 912 (1965-69), 914 (1970-7
£1.78 ex. VAT
In Stock356 / 912 DISTRIBUTOR PLATE #539.09.313
Hold down plate for distributors on 356 ABC and 912.
£10.17 ex. VAT
In Stock356 / 912 IGNITION WIRE HOLDER #616.09.904
Spark plug wire holder. 2 required. 356 and 912.
£3.43 ex. VAT
In StockGENERATOR BOOT #616.109.381.00
Generator pole boot for 356B, C (1960-65). 912 1965 - 69
£4.25 ex. VAT
In Stock356 / 912 / 914 IGNITION WIRES #616.109.952.00
This plug wire set comes with soldered terminals, rubber boots and correct hold downs. Plu
£53.04 ex. VAT
In Stock356 REGULATOR EARLY 12 volt #616.603.202.01A
This new 12V voltage regulator for 356, 356A and 356A (1950-63). This item fits on the sam
£183.80 ex. VAT
In StockREGULATOR SOLID STATE 12 VOLT #616.603.212.00
Solid State Voltage regulator (12V/420W/30Amp) for 356 ABC, 911 and 912`s.
£72.65 ex. VAT
In StockGENERATOR BRUSHES 6 VOLT #616.603.904.02
Two brush set for all models with a 6 Volt generators.
£7.74 ex. VAT
In StockSTARTER MOTOR BUSHING #644.09.401
Bronze starter bushing for all 356`s. Outer diameter is 1.6 cm, inner diameter is 1.3 cm.
£7.65 ex. VAT
In StockBOOT SET VARIOUS 356B/C #644.109.381.00
Engine rubber boot set for 356B and 356C models. It may fit 912 as well. Sold as a set.
£32.20 ex. VAT
In StockO-RING FOR DISTRIBUTOR #999.701.101.50
Rubber seal for distributors on 356 (1950-1955), 356A (1955-1959), 356B (1960-1963), 356C
£5.73 ex. VAT
In Stock356 912 ELECTRONIC DISTRIBUTOR #EL123
HIGH PERFORMANCE ELECTRONIC DISTRIBUTOR FOR 6 & 12 VOLT NEGATIVE EARTH.
£324.87 ex. VAT
In StockOIL TEMP SENDER 6v 12v RE-CALIBR #NLA.107.805.01
6 / 12 VOLT FOR RE-CONDITIOND AND RE-CALIBRATED GAUGES.
£28.56 ex. VAT
In Stock356 / 356A BOOT SET VARIOUS #NLA.109.380.00
Engine boot set for 356 and 356A.
£28.87 ex. VAT
In StockSHIM WASHER KIT FOR DISTRIBUTOR #NLA.602.101.50
Shim and hardware kit for cast iron distributors only.
£164.37 ex. VAT
In StockSLIDING SURFACE FOR ADVANCE #NLA.602.102.00
SLIDING SURFACE FOR ADVANCE WEIGHTS TEFLON 356 / 912.
£4.90 ex. VAT
In Stock356 Distributor Advance Spring #NLA.602.650.04
Advance spring for distributors on 356, A,B,C and 912. Two required. Not to be used on m
£3.87 ex. VAT
In StockCLIP SET FOR CAST DISTRIBUTOR #NLA.602.954.00
Clip set for cast iron distributor.
£26.90 ex. VAT
In StockGENERATOR BRUSHES 12v PAIR #NLA.603.905.00
Two brush set for 912 models with a 12V, 350 / 420 watt generator.
£3.81 ex. VAT
In StockCondenser Bracket for Iron Dist #644.602.900.00
Condenser Bracket for Iron Distributor fits Bosch 056 & 076 condensers.
£14.47 ex. VATShowing 1–30 of 91 results